![]() ![]()
With DSO click SETUP: and choose the correct COM Port (COM3 in this example) and Click OK: Doing this with one BitScope Application sets the port used for all applications so you won't need to do this again. This can be done with most BitScope Apps. AUTO USB CHECK FULL VERSION DOWNLOAD SERIALA serial mouse), you may need to configure the software to. However, if more than one BitScope is connected or there are other FTDI COM Port devices connected to your PC (e.g. Select Devices and Printers: Find the BitScope (it should be listed) and select properties: and then select the Hardware Tab: Here you can see the COM Port number (COM3 in this example).Ĭhoosing the COM Port If only one USB BitScope is connected choosing the COM Port is unecessary All automatically connect with that one BitScope. AUTO USB CHECK FULL VERSION DOWNLOAD DRIVERThe most common reason is to see the COM Port number Windows has assigned when the driver was installed (if you forgot to take note of it at the time). Which COM Port was assigned? Sometimes it's necessary to learn the device properties for a USB BitScope. AUTO USB CHECK FULL VERSION DOWNLOAD INSTALLManual Driver Installation If the failed you may see this: In this case you will need to UNPLUG YOUR BITSCOPE and: and when complete, run it: You will be asked to extract it: and then install it: which may take some time to complete: When the installation is complete you may see this dialog: Take note of the COM Port identifier ( COM3 in this example) as you may need it later. Its appearance may differ a little depending on the edition and version of Windows 7 or 8 you are using (The remainder of this tutorial uses Windows 7) To observe progress click the pop-up dialog to reveal: When the installation completes you will see: Take note of the COM Port identifier ( COM3 in this example) as you may need it later. ![]() ![]() The following pop-up should appear at the bottom right of the desktop. Of course, email us anytime at if you need assistance! Automatic Driver Installation In most cases, there is nothing to do, just plug in the BitScope. if your BitScope still cannot not connect to your PC.if Windows prevents you accessing devices. ![]()
0 Comments
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |